This is to ensure that any paint that gets on the tape is soaked up and not spread over other surfaces when removed. The surface of this tape can also be highly textured. The surface of the masking tape can be coloured to help you identify where the taped areas are. If you are adding painted patterns to a wall, for example. This is mainly used in the car painting industry but can have applications in certain DIY settings. Generally, masking tape is available in 36mm, 38mm, and 44mm, but there is also thinner width available for specialised tasks. There are several different features to look for when buying masking tape, including: Width of masking tape Masking off areas that don’t require paint correctly will save you loads of time with retouching later. If you’ve never masked anything off before, just take your time and go slowly. You can repeat these steps around all skirting, door trims, window frames and ceilings. This will create a seamless gap in the corner. Then, using the putty knife again, place it into the corner and tear the tape off of the roll. When you reach a corner that you need to mask, pull off more tape than your need from the roll. This will sort out any alignment issues and ensure that paint can’t get under the tape. Once you’ve finished applying the masking tape, you can go back with a putty knife and use it to press the tape down. This will help you line up the masking tape with the edge of the skirting much easier. If you are taping off a skirting board, for example, you can push the roll of tape against the wall. Then, move along the surface you are taping slowly, pressing the tape down as you go. Next, start in a corner, and rip the end of the tape at an angle this will help you get into the very corner of the room much easier. If there is dust on the surface, the tape will stick to the dust and not the surface itself, so it will peel very easily. You can use a clean paintbrush for this to remove any dust. The first step to applying masking tape is to ensure the surface you are applying it to is clean (in some occasions you can use white spirit or methylated spirit to clean the surface).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |